
De camerabedieningseenheid AK-UCU500 (CCU) ondersteunt zowel 4K- als HD-formaten, zodat gebruikers camerasystemen van hoge kwaliteit met glasvezeltransmissie via over lange afstanden kunnen configureren tegen lagere kosten
Enkele 2U camerabedieningseenheid met rackmontage voor een parallelle UHD- en HD/SD-uitvoer over een afstand van 2000 m

- Afbeeldingen
Please see below the services available for this product. You can also use this section to access the general Service & Downloads area of the website or contact our Technical Support team.
ALGEMENE SERVICE EN DOWNLOADS CONTACT OPNEMEN MET DE TECHNISCHE ONDERSTEUNINGPlease see below the services available for this product. You can also use this section to access the general Service & Downloads area of the website or contact our Technical Support team.
ALGEMENE SERVICE EN DOWNLOADS CONTACT OPNEMEN MET DE TECHNISCHE ONDERSTEUNINGThere are currently no key services available.
Please see below the services available for this product. You can also use this section to access the general Service & Downloads area of the website or contact our Technical Support team.
ALGEMENE SERVICE EN DOWNLOADS CONTACT OPNEMEN MET DE TECHNISCHE ONDERSTEUNINGThere are currently no other services available.
Specifications
Power Supply | AK-UCU500P/AK-UCU500PS: 100 V - 120 V AC, 50 Hz/60 Hz AK-UCU500E/AK-UCU500ES: 100 V - 240 V AC, 50 Hz/60 Hz |
---|---|
Power Consumption | 500 W (Without camera connected: 70 W) |
Capacity for Supplying Power to a Camera | 240 V AC (tolerance: 5%), 1.46 A , 50 Hz/60 Hz |
Operating Temperature | 0°C to 40°C (32°F to 104°F) |
Humidity | 10% to 90% (no condensation) |
Weight | Approx. 8.8 kg (19.4 lb) |
Dimensions (W x H x D) | 424 mm x 88 mm x 401 mm (16-5/8 inches x 3-7/16 inches x 15-13/16 inches) (excluding protrusions) |
Video Output | 3G/HD/SD-SDI: 7 lines (embedded audio is supported only for HD signals) HD/SD-SDI: 1 line (shared with picture monitor output*1 ; embedded audio is supported only for HD signals) Analog composite: 2 lines (1 line shared with picture monitor output*1) |
HD Trunk Output | HD-SDI: 1 line (cannot be used in UHD/HS mode) |
Return Input | 3G-HD/HD/SD-SDI: 4 lines (RET1 input has active-through output) Analog composite: 1 line |
Prompter Input | HD-SDI: 1 line (with active-through output) Analog composite: 2 lines (through output of 1 and input of 2 share the connector*1) It is not terminated when the unit is turned OFF. No through output. |
Reference Input | BB (black burst) / tri-level*2: 1 line (automatic termination, connect to upper connector; BB signal and tri-level signal automatically recognized, with loop-through output) |
Microphone Output | 0 dBm/600 ohm, 2 lines (XLR, 3-pin, male) |
Communication | Intercom input/output (ENG / PROD, 0 dBm, 600 Ω (4 W) / 1 V [p-p], 200 Ω (RTS), 4 W / RTS / CLRCOM) : 2 lines*1 PGM input (0 dBm/600 Ω) : 2 lines Tally input (red, green, yellow) : 1 input each |
AUX | WFM control 6-bit (open collector output, terminal shared with camera microphone gain setting*1) Camera microphone gain setting input 5-bit (photo-coupler input, terminal shared with WFM control*1) Down-conversion system setting input 2-bit (photo-coupler input) |
Trunk | RS-422 / RS-232C 2 lines*1 |
Front ROP | RS-422 1 line, 16 V DC output (only one of this and REAR ROP can be selected at one time via the menu or the [ROP FRONT/REAR] selection switch on the front panel) |
Rear ROP | RS-422 1 line, 16 V DC output (only one of this and FRONT ROP can be selected at one time via the menu or the [ROP FRONT/REAR] selection switch on the front panel) |
MSU | RS-422 1 line, GPI for control |
LAN Trunk | LAN connection with camera side via an optical cable*3 1 line, 100BASE-T, 1000BASE-T |
LAN | Personal computer connection for distribution via the Web*3 1 line, 10BASE-T, 100BASE-TX (use a crossover cable when connecting directly with a personal computer) |
Note | *1: Depending on the setting, only one of them can be selected at one time. *2: The BB (black burst) signal and tri-level sync signal of the reference input are recognized automatically. *3: IP video cannot be transmitted when [CCU MODE] is set to [2160/23.98p], [2160/23.98PsF], [1080/23.98p], or [1080/23.98PsF]. *4: Can be provided from CCU |